ACX Ready / Noise floor too high

ACX says your noise floor is too high

"Each file must have a noise floor no higher than -60dB RMS to avoid background noise distractions."

ACX, ACX audio submission requirements

The noise floor is the level of the quietest part of your file, when you are not speaking. It's mostly room sound: hiss from the microphone and interface, plus fans, fridges, traffic and heating. If it measures above -60 dB, ACX returns the file.

Why it happens

Home rooms are rarely silent. A laptop fan or a fridge in the next room can sit around -55 dB on a recording. Cheap USB microphones and high gain settings add hiss.

The noise floor also rises whenever you turn the file up. A recording that passes at -62 dB fails at -56 dB once you raise it 6 dB to meet the RMS range. That's why noise and loudness have to be fixed together.

How to fix it in Audacity

  1. Find two or three seconds of room tone where you aren't speaking, and select it.
  2. Open Effect > Noise Removal and Repair > Noise Reduction and click Get Noise Profile.
  3. Select the whole track, open Noise Reduction again and apply it. Start with a reduction of 6 to 12 dB. More than that tends to make the voice sound watery.
  4. Set loudness and peaks after noise reduction, then run Analyze > ACX Check.

A low-cut filter also helps with rumble. Effect > EQ and Filters > High-Pass Filter at around 80 Hz removes traffic and air conditioning hum without touching the voice much.

How to fix it in Reaper

  1. Add ReaFIR to the track and set its mode to Subtract.
  2. Tick Automatically build noise profile and play a few seconds of room tone. Untick it once the profile is built.
  3. Play back and lower the profile curve if the voice starts to sound thin.
  4. Add a high-pass filter in ReaEQ at about 80 Hz to remove rumble.

When software isn't enough

If the noise is almost as loud as your voice, any noise reduction leaves artefacts. Turning off fans, recording at night, or hanging duvets around the microphone often helps more than any plug-in.

How ACX Ready fixes it

Checking is free and you see the before and after numbers first. Downloading a whole book is £30 (about $41).

Measure your noise floor free

Get your noise floor, RMS and peak numbers for any chapter. Your recording stays on your computer.

Check a chapter free

Fixing a whole book is £30 (about $41), with a full refund if ACX still rejects it. See what's included.

Questions

What noise floor does ACX require?

No higher than -60 dB RMS. Lower is better: -65 dB or below gives a margin.

How is the noise floor measured?

Tools like Audacity's ACX Check measure the quietest part of the file, which is normally the pauses between sentences.

Why did my noise floor fail after I made the file louder?

Raising the volume raises the background noise by the same amount. Reduce the noise first, then set the loudness.

Other ACX rejection reasons